Page 1 of 1
#1 TDA7293 chip amps
Posted: Fri Jul 26, 2013 10:58 am
by pre65
I have a few TDA7293 amp chips in my spares box.
Are they worth playing with ? Not for hi-fi use I hasten to add.
http://pdf1.alldatasheet.com/datasheet- ... A7293.html
There are PCBs for them on e-bay quite cheap.
#2
Posted: Fri Jul 26, 2013 12:09 pm
by JamesD
Hi Phil,
this is a nice little chip amp if used properly and it can be used in parallel to drive complex loads successfully.
Here is a brief page about how to use it
http://www.rotgradpsi.de/mc/amp51/amp51 ... tfall.html
I've heard this run off against the popular LM3886. It isn't going to match the 833
but it is a decent little amp when used properly...
J
#3 Re: TDA7293 chip amps
Posted: Fri Jul 26, 2013 4:34 pm
by brig001
pre65 wrote:Not for hi-fi use I hasten to add.
Go one then Philip, I'll bite. What do you want to use them for
Brian
#4
Posted: Fri Jul 26, 2013 5:02 pm
by pre65
I was thinking of an amp for the television, as the built in speakers are crap, with a capital K.
But the problem is, a decent toroid for the PSU would probably cost more than a cheapo stereo amp off e-bay.
Now where oh where is my old T amp ?
#5
Posted: Fri Jul 26, 2013 5:39 pm
by brig001
I suppose it depends how much power you need. The chip will work down to +/-12V which will give nearly 9W into 8 ohms. A 12-0-12 transformer will give more and shouldn't be too expensive. Why toroid? An EI core will be cheaper; the whole PSU should be less than £20 even if you had to buy everything new.
#6
Posted: Fri Jul 26, 2013 5:44 pm
by pre65
In that case my 0-18v + 0-18v toroid will do.
#7
Posted: Fri Jul 26, 2013 5:59 pm
by JamesD
Phil,
Use a Laptop smps
Ok use four of them....
J
#8
Posted: Fri Jul 26, 2013 6:00 pm
by brig001
That should do the job. Not sure you need all that power though, but if the parts are free, why not