Page 2 of 2

#16 Re: Yet Another OTL

Posted: Mon Apr 15, 2019 5:34 am
by Ali Tait
I’m very much liking them so far. Loud as I could wish with the mini beast, though on paper should not be so as they are quite a reactive load and apparently dip to under three ohms. I don’t hear any problems with this subjectively though.

#17 Re: Yet Another OTL

Posted: Thu May 02, 2019 7:41 pm
by Ali Tait
Bit more progress, fitted the K&K HT delay boards-

Image

Getting there-


Image

Canterbury were going to be 6-8 weeks for the toroids, so went to Amethyst, who've said two weeks. That'll do!

#18 Re: Yet Another OTL

Posted: Sat May 04, 2019 5:54 pm
by Ali Tait
Pretty much done now, or at least as far as I can go until I get the toroids Amethyst are making for me, then it's just a case of wiring up the filament supplies and Bob's yer mother's brother. :mrgreen:


Image


Image

#19 Re: Yet Another OTL

Posted: Sat May 04, 2019 5:57 pm
by IslandPink
Very neat and shiny !

#20 Re: Yet Another OTL

Posted: Sat May 04, 2019 6:01 pm
by Ali Tait
Ta Mark, here's hoping it works. :D

#21 Re: Yet Another OTL

Posted: Sat May 04, 2019 6:06 pm
by Cressy Snr
Shoddy ! :D